Editing Psion Series 5mx Hinge Repair (section)

=== Which version to print ===

The model is published with '''four print profiles'''. Two of them slice the chassis into a tray plus a separate hinge spine; the other two print it as one piece.<ref name="mw" />

{| class="wikitable styled-table" style="width:100%; text-align:left;"
|+'''Published print profiles'''<ref name="mw" />
! Profile !! Settings !! Time !! Notes
|-
| Sliced, AMS || 0.2 mm layer, 2 walls, 15 % infill || 3.3 h || Chassis and hinge spine as separate parts
|-
| Sliced, no AMS || 0.2 mm layer, 2 walls, 15 % infill || 1.8 h || As above, single material
|-
| '''Single piece''' || 0.2 mm layer, 2 walls, 15 % infill || 3.6 h || '''Recommended'''
|-
| Fine || 0.2 mm nozzle, 0.1 mm layer, 4 walls, 15 % infill || 17.8 h || Slowest, finest detail
|}

'''Print the single-piece version.''' The two-part versions are quicker and easier to print, but they put a joint exactly where the spring wires apply their load — which is the failure you are trying to eliminate.