Editing Osborne 1 Capacitor Replacement Guide (section)

== Recapping Procedure ==

# '''Unplug and discharge''' – Disconnect from mains and allow several minutes for capacitors to discharge. For safety, short large power supply capacitors with a resistor before handling.
# '''Disassemble''' – Remove the rear case screws and gently lift off the case. Disconnect the keyboard and CRT cables, labelling if needed.
# '''Remove logic and power supply boards''' – Take care with the CRT and high-voltage areas.
# '''Desolder old capacitors''' – Use a temperature-controlled iron (350–375 °C) and desoldering braid or pump. Take care not to lift PCB pads, especially on older fibreglass boards.
# '''Clean pads and inspect for damage''' – Remove any leaked electrolyte with isopropyl alcohol and a soft brush.
# '''Install new capacitors''' – Observe polarity (long lead = positive). Match lead spacing and keep replacement cans as low-profile as possible to avoid mechanical interference.
# '''Check work''' – Inspect for solder bridges, correct orientation, and clean joints.
# '''Reassemble and test''' – Refit boards, reconnect all cables, and power up via a current-limited supply or with a fused mains lead.