Editing CRT Discharge Procedure (section)

== Discharge Procedure ==
[[File:CRT Anode Cap.jpg|thumb|CRT Anode Cap]]

=== Step-by-Step ===

# Ensure the system is **unplugged** and left off for 30 minutes.
# Attach your alligator clip to a grounded part of the CRT or chassis.
# Hold the **screwdriver by the insulated handle only**.
# Carefully slide the screwdriver tip '''under the rubber suction cup''' (anode cap) on the CRT.
# You may hear a '''"pop" or crackle sound''' — this is normal.
# Hold contact for at least **10 seconds** to allow the charge to dissipate.
# Remove the anode cap by pinching and lifting it free from the CRT.

=== Repeat Discharge ===
Some CRTs can '''regain charge due to internal capacitance'''. After 10–15 minutes, it's a good idea to '''discharge the anode again''' before handling.