Editing Apple Disk II Technical Procedures

The '''Disk II Technical Procedures''' are the [[Disk II]] section of Apple's ''Apple Service Technical Procedures: Apple II/Apple III Archived Products, Volume One'' (part number 072-0231), 31 pages with section pages dated from 1982 to January 1990. Apple numbers pages by section (2.4 is the fourth page of section 2).

== Contents ==
From the section's table of contents:
* Section 1, Take-Apart: cover, disk drive cable, analog card
* Section 2, Troubleshooting: introduction, how to use the symptom chart, symptom chart, analog card troubleshooting (system will not boot, drive will not read or write, trouble reading, trouble writing, write-protect circuit faults)
* Section 3, Adjustments: DSPEED, write-protect switch
* Section 4, Preventive Maintenance: read/write head, head load button, motor drive belt
* Section 5, Illustrated Parts List: finished goods assembly (Figure 1), internal parts (Figure 2), ICs (Figure 3)

== What this document does not contain ==
* Module-level service only: no schematic of the analog card or the controller card, and no component values.

== Pages that cite this document ==
* [[Apple II General Maintenance]]: cites Section 4, pp. 4.2-4.4
* [[Disk II]]: cites pp. 1.3–1.6, p. 2.3, pp. 2.4–2.8, pp. 3.3–3.5, pp. 4.2–4.4
* [[Floppy Drive Repair]]: cites p. 2.3, pp. 2.4–2.8, p. 2.5, pp. 3.3–3.4, pp. 4.2–4.4

<pdf>File:Apple Disk II Technical Procedures.pdf</pdf>

Download: [[:File:Apple Disk II Technical Procedures.pdf|Apple Disk II Technical Procedures.pdf]]

[[Category:Apple Service Source]]
[[Category:Service Manuals]]