Macintosh 128K/512K Service Source: Difference between revisions
No edit summary Tag: Manual revert |
P4: turn document holder into a real documentation page (verification drive) |
||
| Line 1: | Line 1: | ||
The '''Macintosh''' volume of Apple's ''Service Source'' is a '''79-page''' service manual for the '''Macintosh 128K and 512K'''. The PDF was distilled on 15 December 1995. | |||
This is one of the most important documents on this wiki, because its '''Adjustments - Voltage''' procedure is the origin of the "+5 V 4.85-5.15 V / +12 V 11.90-12.75 V" figures that have been copied onto Macintosh pages they do not belong to. Here is the procedure as Apple actually prints it. | |||
== The voltage adjustment, verbatim in substance == | |||
Apple's procedure (Adjustments, pdf pp. 61-66): | |||
# Set the voltmeter to the 20 V scale. | |||
# Connect the '''Macintosh voltage test cable, Apple part number 077-0135''', to the '''external drive port'''. Apple cautions that shorting the test cable plugs to each other can damage the computer, and says to pull the rubber hoods over the plugs. | |||
# Connect the black voltmeter lead between the meter's ground terminal and the computer chassis. | |||
# Connect the '''orange''' test-cable lead to the voltage input terminal. Switch on, and adjust the voltage regulator on the '''power/sweep board''' to between '''11.90 V and 12.75 V'''. | |||
# Switch off, disconnect the orange lead, then connect the '''red''' lead. Switch on, and adjust the regulator to between '''4.85 V and 5.15 V'''. | |||
# Switch off, disconnect, and repeat both tests to verify both voltages are in tolerance. '''If the power/sweep board cannot be adjusted so that both voltages fall within tolerance, replace the board.''' | |||
Apple also notes that the voltages must be verified after replacing either the logic board or the power/sweep board, and that because the adjustment is made from the rear of the computer a '''mirror''' should be used to see the screen rather than reaching around the machine. | |||
Three things follow from this, and they matter because the figures have been mis-applied elsewhere on this wiki: | |||
* The upper +12 V bound is '''12.75 V''', not 12.7 V. | |||
* The adjustment belongs to the '''power/sweep board''' of the 128K, 512K and Plus. Machines without that board - the SE, SE/30, Classic, Classic II, Color Classic and everything later - have no such adjustment, and their ''Service Source'' Adjustments chapters cover yoke and video only. | |||
* It is measured at the '''external drive port''' with a specific Apple test cable, not by probing the board. | |||
== Specifications as printed == | |||
<templatestyles src="Template:StyledTable/styles.css" /> | |||
{| class="wikitable styled-table" | |||
|- | |||
! Item !! Value | |||
|- | |||
| CPU || Motorola 68000 at '''7.83 MHz''', 32-bit internal data bus | |||
|- | |||
| RAM || 128K or 512K | |||
|- | |||
| ROM || 64K | |||
|- | |||
| PRAM || CMOS custom chip with a '''4.5 V user-replaceable battery''' backup, 256 bytes; retains settings with the machine off | |||
|- | |||
| Line voltage || '''105-125 VAC''' (no 220-240 V figure is printed in this manual) | |||
|- | |||
| Frequency || 50-60 Hz | |||
|- | |||
| Maximum power || '''60 W''' | |||
|- | |||
| Size / weight || 13.6 in (34.5 cm) H x 9.6 in (24.4 cm) W x 10.9 in (27.6 cm) D; 16 lb 8 oz (7.5 kg) | |||
|} | |||
The '''4.5 V alkaline''' cell is the one to note: it is not a lithium half-AA, so leakage from it is alkaline and neutralised with vinegar, whereas the lithium cells in later Macs need bicarbonate. See [[Battery Explosion, Capacitor or Corrosion Damage]]. | |||
== Contents == | |||
* '''Basics''' - Overview (pdf pp. 3) | |||
* '''Specifications''' - Processor, Memory, Disk Storage, I/O Interfaces, I/O Devices, Sound and Video, Electrical, Physical (pdf pp. 5-12) | |||
* '''Troubleshooting''' - General, symptom charts for Video, Drives, Peripherals and Miscellaneous (pdf pp. 14-22) | |||
* '''Take Apart''' - Cover, '''Power/Sweep Board''', Logic Board, CRT, Floppy Drive, Chassis (pdf pp. 24-43) | |||
* '''Upgrades''' - Floppy Drive Upgrade Kit, Logic Board Upgrade Kit, '''400K Drive ROM Upgrade''' (pdf pp. 45-59) | |||
* '''Adjustments''' - '''Voltage''', Yoke, Tilt Adjustment, Video (pdf pp. 61-77) | |||
* '''Exploded View''' (pdf pp. 78-79) | |||
== What this manual does not contain == | |||
No parts list, no schematic and '''no component values'''. The voltage regulator on the power/sweep board is identified by position in a drawing, not by a designator or a part number, and its trimmer is not numbered in this volume. There is no analogue-board capacitor list of any kind. The Electrical specification gives the 105-125 V machine only. | |||
== Pages that cite this document == | |||
* [[Macintosh 128K/512K General Maintenance]] and [[Macintosh 128K/512K Troubleshooting]] - the voltage adjustment and the 4.5 V PRAM cell. | |||
* [[Macintosh 128K]], [[Macintosh 512K]], [[Macintosh 512Ke]] | |||
* [[Macintosh Plus Service Source]] - the same procedure and the same test cable on the Plus. | |||
''Warning:'' these machines contain a high-vacuum picture tube and a live analogue/power-sweep board. Follow [[CRT Discharge Procedure]] before working inside one; Apple's own Take Apart chapter opens with the same warning. | |||
<pdf> File:Macintosh 128k.512k.pdf </pdf> | <pdf> File:Macintosh 128k.512k.pdf </pdf> | ||
Download | Download: [[:File:Macintosh 128k.512k.pdf|Macintosh 128k.512k.pdf]] | ||
[[Category:Service Manuals]] | [[Category:Service Manuals]] | ||
[[Category:Apple Vintage Computers]] | [[Category:Apple Vintage Computers]] | ||
[[Category:Apple Service Source]] | [[Category:Apple Service Source]] | ||