Atari 800XL Troubleshooting Guide: Difference between revisions

Line 148:

* Statistically, RAM and socket faults are most common, followed by ROM and POKEY failures.

* Fit sockets for all replaced chips and recap ageing boards for long-term reliability.

== Diagnostic order and the Star Raiders test ==

On the Atari 8-bit machines the components fail, statistically, in this order: '''RAM → OS ROM → POKEY → GTIA/ANTIC → CPU'''. Work through them in that order. The '''Star Raiders''' cartridge is a quick diagnostic: it exercises ANTIC, the CPU and GTIA/CTIA, so if it runs those three are good and the fault is narrowed to the PIA, the OS ROM, the MMU or the RAM. Before swapping chips, leave the machine powered for about ten minutes and feel for an overheating RAM chip, and make sure the RAM, OS ROM, ANTIC, MMU, PIA and CPU are all fully seated (reseating cures many garbage-screen / no-boot faults).<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>

== Power and clock ==

* '''Power''': the external "ingot" supply, an oxidised power switch and a cracked DC power connector all cause dead or intermittent operation. Check the switch and connector, and test/replace the '''470 uF 16 V''' radial electrolytic in the left-rear corner of the board.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>

* '''CPU clock and reset''': check for a clean '''1.79 MHz''' clock at the 6502/SALLY (pin 37), and that RESET pulses low then high at power-up. A RESET stuck low points to the reset circuit.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>

== Keyboard and POKEY ==

POKEY scans the keyboard and generates the sound and the SIO serial signals. '''A dead keyboard while sound still works''' is a classic POKEY (or keyboard-membrane) fault; SIO/peripheral problems also point to POKEY.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>

== Internal BASIC (XL/XE) ==

The XL/XE machines have BASIC built in. A bad internal BASIC ROM can stop the machine booting; '''hold OPTION at power-on to disable internal BASIC''' as a test (and to run software that needs BASIC off). If the machine boots with OPTION held but not without, suspect the BASIC ROM.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>

== References ==

== Related Pages ==

@@ Line 148: / Line 148: @@
 * Statistically, RAM and socket faults are most common, followed by ROM and POKEY failures.
 * Fit sockets for all replaced chips and recap ageing boards for long-term reliability.
+== Diagnostic order and the Star Raiders test ==
+On the Atari 8-bit machines the components fail, statistically, in this order: '''RAM → OS ROM → POKEY → GTIA/ANTIC → CPU'''. Work through them in that order. The '''Star Raiders''' cartridge is a quick diagnostic: it exercises ANTIC, the CPU and GTIA/CTIA, so if it runs those three are good and the fault is narrowed to the PIA, the OS ROM, the MMU or the RAM. Before swapping chips, leave the machine powered for about ten minutes and feel for an overheating RAM chip, and make sure the RAM, OS ROM, ANTIC, MMU, PIA and CPU are all fully seated (reseating cures many garbage-screen / no-boot faults).<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>
+== Power and clock ==
+* '''Power''': the external "ingot" supply, an oxidised power switch and a cracked DC power connector all cause dead or intermittent operation. Check the switch and connector, and test/replace the '''470 uF 16 V''' radial electrolytic in the left-rear corner of the board.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>
+* '''CPU clock and reset''': check for a clean '''1.79 MHz''' clock at the 6502/SALLY (pin 37), and that RESET pulses low then high at power-up. A RESET stuck low points to the reset circuit.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>
+== Keyboard and POKEY ==
+POKEY scans the keyboard and generates the sound and the SIO serial signals. '''A dead keyboard while sound still works''' is a classic POKEY (or keyboard-membrane) fault; SIO/peripheral problems also point to POKEY.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>
+== Internal BASIC (XL/XE) ==
+The XL/XE machines have BASIC built in. A bad internal BASIC ROM can stop the machine booting; '''hold OPTION at power-on to disable internal BASIC''' as a test (and to run software that needs BASIC off). If the machine boots with OPTION held but not without, suspect the BASIC ROM.<ref name="atari8">[https://8bithardware.wixsite.com/website/post/atari-8-bit-400-800-xl-xl-pictorial-fault-guide Atari 8-bit pictorial fault guide], 8bithardware; [https://atari-owner.com/club/articles/black-screen-problems-xl-xe-fix-checklist.25/ Black Screen [XL/XE] Fix Checklist], Atari Owners Club; and AtariAge repair threads. Source for the RAM→ROM→POKEY→GTIA/ANTIC→CPU failure order, the Star Raiders diagnostic cartridge, the seated-socket checks, the PSU 470 uF capacitor and switch/connector faults, and the SALLY 1.79 MHz clock/reset checks.</ref>
+== References ==
+<references />
 == Related Pages ==