Macintosh Plus Capacitor Replacement Guide

Replacing electrolytic capacitors (recapping) in your Macintosh Plus is crucial for ensuring reliability, stable voltages, and a crisp video image. Due to age, capacitors can dry out, leak, or lose effectiveness.

Capacitor Inspection

Regularly inspect capacitors for these signs of failure:

• Bulging Tops: A dome-shaped or expanded capacitor top.
• Leaking electrolyte: Brownish or white crust near capacitor leads.
• Corrosion: Discoloration or corrosion on the PCB around capacitors.

File:MacintoshPlus CapacitorFailure.jpg

Typical capacitor failures

Capacitor List

Replace all major capacitors proactively to prevent potential failures. Here is the detailed list:

Analog Board Capacitors

• C1: 3.9µF 35 V non-polarized (recommended replacement: 4.7µF 100V non-polar film capacitor)
• Main Filter Capacitor: 4700µF (270 V rating, axial)
• High-voltage Capacitors: 10µF (160 V)
• Medium-value Capacitors: 22µF, 33µF, 47µF (typically 16–50 V)

Analog board capacitor locations

Logic Board Capacitors

The logic board rarely needs recapping but if done, these capacitors are required:

• 5x 33µF (16 V axial capacitors)
• 1x 1µF (50 V axial capacitor)

Capacitor Replacement Procedure

File:MacintoshPlus RecapProcess.jpg

Desoldering capacitors safely

1. CRT Safety: Fully discharge the CRT and ensure the system is unplugged.
2. Disassembly: Remove analog board carefully, noting connector placements.
3. Desoldering: Carefully desolder old capacitors, using a solder sucker or braid.
4. Replacement: Install new capacitors with correct polarity (observe + and - markings).
5. Soldering: Solder the new capacitor leads and trim excess lead length.
6. Inspection: Check all solder joints to confirm clean, secure connections.
7. Final Check: Verify no shorts between power rails with a multimeter before powering on.

Recommended Tools

• Soldering iron (temperature-controlled recommended)
• Desoldering pump or braid
• Multimeter (for voltage verification)
• Anti-static brush, isopropyl alcohol
• Safety glasses and insulated gloves

File:MacintoshPlus RepairTools.jpg

Tools for recapping

Voltage Adjustment Post-Recap

After recapping, verify and adjust voltages for optimal stability:

• +5 V Line: Should measure between 4.85 V–5.15 V
• +12 V Line: Should measure around 11.9–12.7 V
• Adjust using the trim potentiometer (R56) on the analog board as needed.

File:MacintoshPlus VoltageAdjustment.jpg

Adjusting voltage on the analog board

Additional Tips

• Periodically power on the Macintosh Plus to maintain capacitor health.
• Always dispose of old capacitors responsibly.