Atari 520ST+
The Atari 520ST+ (sometimes written 520ST Plus) is a variant of the Atari 520ST home computer that shipped with 1 MB of RAM instead of the standard 512 KB. Introduced in 1986, it was created to differentiate the higher-memory version from the base 520ST, particularly after the 1040STF established 1 MB as the standard for the ST line.
| Atari 520ST+ with SM124 monochrome monitor | |
| Specifications | |
|---|---|
| Manufacturer | Atari Corporation |
| Type | Home computer / personal computer |
| Released | January 1, 1986 |
| Discontinued | 1987 (superseded by STF/STFM variants) |
| Intro price | Approximately US$599–US$799 (varied by bundle and market) |
| CPU | Motorola MC68000 @ 8 MHz |
| Memory | 1 MB RAM |
| Storage | External 3.5-inch floppy drive (Atari SF354 SSDD 360 KB or SF314 DSDD 720 KB); external ACSI hard disks |
| Display | 320×200 (16 colours), 640×200 (4 colours), 640×400 (mono) |
| Sound | Yamaha YM2149F (3 voices + noise) |
| Dimensions | 70 mm × 476 mm × 241 mm (2.75 × 18.75 × 9.5 in) |
| Weight | ≈4.3 kg (9.5 lb) |
| OS / Firmware | Atari TOS 1.00 / 1.02 (192 KB ROM) |
| Predecessor | Atari 520ST |
| Successor | Atari 520STFM |
The 520ST+ retained the original "short-case" form factor with an external power supply and no internal floppy drive, making it physically identical to the standard 520ST. The "+" suffix was Atari's way of indicating the doubled RAM without changing the model number entirely. It was sold primarily in European markets.
History
editWhen the ST line launched in 1985, the 520ST shipped with 512 KB of RAM and the 260ST had 256 KB. By 1986, Atari had introduced the 1040STF with 1 MB of RAM and an internal floppy drive, at a price point that made the 512 KB 520ST look less competitive.
Rather than discontinue the short-case design entirely, Atari upgraded some 520ST units to 1 MB of RAM and marketed them as the "520ST+". This allowed retailers to offer a 1 MB machine at a lower price point than the 1040STF (which included the internal floppy drive and, in some models, an internal power supply).
The 520ST+ was not a distinct hardware design — it used the same motherboard as the 520ST with additional or different RAM chips installed to provide 1 MB. The naming convention simply distinguished it from the 512 KB models in dealer and consumer documentation.
Architecture
editThe 520ST+ is architecturally identical to the Atari 520ST, differing only in RAM capacity:
- CPU: Motorola MC68000P8 or MC68000FN8 @ 8.00 MHz
- Architecture: 16/32-bit (32-bit internal, 16-bit external data bus, 24-bit address bus)
- RAM: 1 MB, using 16× 256k×4 or equivalent DRAM configuration
- ROM: 192 KB TOS (TOS 1.00 in 6× 32 KB ROMs, or TOS 1.02 in 2× 128 KB ROMs on later units)
- Custom ICs: Shifter (C025914), GLUE (C025915), MMU (C025912), DMA (C025913) — identical to standard ST
Major ICs
edit| Function | Part Number | Notes |
|---|---|---|
| CPU | MC68000P8 / MC68000FN8 | 8 MHz, DIP-64 or PLCC-68 |
| Video Shifter | C025914-38 | Pixel serialiser |
| GLUE | C025915-38A | Bus timing, address decode |
| MMU | C025912-38 / C100109 | DRAM controller; later revision on some boards |
| DMA Controller | C025913-38 | ACSI/floppy DMA |
| FDC | WD1772-00-02 | Floppy disk controller |
| MFP | MC68901 | Timers, interrupts, UART |
| ACIA (×2) | MC6850 | Keyboard/IKBD and MIDI |
| Sound/PIO | YM2149F | 3-voice PSG + I/O |
| RS-232 drivers | MC1488 / MC1489 | Serial port level conversion |
Connectors
editIdentical to the Atari 520ST:
- Video/Monitor: 13-pin DIN (analog RGB, mono, sync, audio)
- Serial (Modem): DB-25 male, RS-232C
- Parallel (Printer): DB-25 female
- MIDI In/Out: Two 5-pin DIN connectors
- External Floppy: 14-pin DIN
- ACSI (Hard Disk): DB-19 female
- Cartridge: 40-pin edge connector
- Joystick/Mouse: Two DE-9 male ports
- Power: 7-pin DIN (external PSU: +5V, +12V, −12V)
Display
editSame three display modes as all ST-family machines:
- Low resolution: 320×200, 16 colours from 512-colour palette, ~50/60 Hz
- Medium resolution: 640×200, 4 colours, ~50/60 Hz
- High resolution (mono): 640×400, monochrome, ~71.2 Hz (requires SM124/SM125)
Sound
edit- PSG: Yamaha YM2149F — 3 square-wave channels + noise, 5-bit envelope
- MIDI: Built-in MIDI In/Out at 31.25 kbaud
- Audio output: Mono line-level on monitor DIN connector
Comparison with Other ST Models
edit| Feature | 260ST | 520ST | 520ST+ | 520STFM | 1040STF |
|---|---|---|---|---|---|
| RAM | 256 KB | 512 KB | 1 MB | 512 KB / 1 MB | 1 MB |
| Internal Floppy | No | No | No | Yes (DSDD) | Yes (DSDD) |
| RF Modulator | No | No | No | Yes | No |
| Internal PSU | No | No | No | Yes | Yes |
| Case Style | Short | Short | Short | Long | Long |
Service and Repair
editThe 520ST+ shares all service procedures with the standard ST family:
See Also
edit- Atari 260ST — 256 KB entry-level model
- Atari 520ST — Standard 512 KB model
- Atari 520STM — 520ST with RF modulator
- Atari 520STFM — 520ST with floppy and RF modulator
- Atari 1040ST — 1 MB with internal floppy
References
edit