Apple Performa Display
The Apple Performa Display is a 14-inch colour monitor with a fixed 640 × 480 resolution and a 0.39 mm dot pitch, sold for the Macintosh Performa range from September 1992 to July 1994.[1] Apple treated it as a whole-unit exchange: there are no service parts, adjustments or take-apart procedures, and almost every cure in Apple's symptom charts is "Replace monitor".[1][2] Its sibling, the Apple Performa Plus Display, has the same specification in Apple's Service Source but a finer 0.29 mm dot pitch.[1] EveryMac lists the Performa Display as introduced with the Performa 400 at US$305.[3]
Specifications
[edit | edit source]| Item | Specification |
|---|---|
| Picture tube | M37118X, 14 in diagonal shadow mask, 11.9 in viewable |
| Dot pitch | 0.39 mm (Performa Plus: 0.29 mm)[1] |
| Resolution | 640 × 480 |
| Scan rates | Horizontal 35.0 kHz; vertical 66.7 Hz |
| Active area | 240 × 180 mm (9.5 × 7 in) |
| Input signals | Linear RGB; composite sync at TTL level |
| Controls | Front panel: power switch, brightness, contrast |
| Power | 120 V AC ± 10 %, 60 Hz; 85 W |
| EHT | 24 kV |
| Size | 350 mm high, 350 mm wide, 360 mm deep |
| Warm-up | 30 minutes to meet all specifications |
Apple prints only the 120 V mains rating, although its parts list has separate exchange units for Australia, Europe and the Pacific region.[2][1] EveryMac gives the viewable size as 13.0 inches where Apple's Service Source gives 11.9 inches.[3][2]
Controls
[edit | edit source]Apple's locator drawing shows vertical shift, horizontal shift, brightness, contrast and the on/off switch under the front of the screen, and H.WIDTH and V.HEIGHT controls at the rear beside the power cord.[1]
Troubleshooting
[edit | edit source]Apple's charts start from the surroundings: a distorted raster or a jittering, flashing picture is first checked by moving the display away from electrical equipment and switching off fluorescent lights. Beyond that the display was exchanged as a unit.[2]
| Symptom | Apple's cure | Service Source page |
|---|---|---|
| Raster too short, tall, narrow or wide; raster not centred; no raster | Replace monitor. | Troubleshooting 3 |
| Abnormal or distorted raster | 1. Move the display away from electrical equipment and switch off fluorescent lights. 2. Adjust brightness and contrast. 3. Replace monitor. | 3 |
| Picture breaks into diagonal lines; picture rolls; a single vertical or horizontal line on a black raster | Replace monitor. | 4 |
| Predominant colour tint; picture too dark or too bright; brightness or contrast cannot be adjusted | Replace monitor. | 5 |
| Out of focus; out of convergence; black spots on the screen (burnt phosphor) | Replace monitor. | 6 |
| Picture jitters or flashes | 1. Move the display away from electrical equipment and switch off fluorescent lights. 2. Check that all ground cables are secure. 3. Replace monitor. | 6 |
Apple's 1996 service guide repeats the same chart.[1] Apple's Service Source for the display has no take-apart, adjustment or exploded-view chapter and no component values.[2] Anyone opening the case needs to discharge the CRT first; see CRT Discharge Procedure and Capacitor Failure Symptoms.
Documentation
[edit | edit source]- Apple Performa Display/ Plus Service Source: Apple's 11-page Service Source for both displays.
- Apple's 1996 service guide Macintosh Displays and Video Cards, Apple Performa Display/Plus chapter, pp. 191-195.[1]
Related pages
[edit | edit source]References
[edit | edit source]- ↑ 1.0 1.1 1.2 1.3 1.4 1.5 1.6 1.7 Apple Computer, Macintosh Displays and Video Cards (service guide, September 1996), hosted as File:Apple Macintosh Displays and Video Cards Service Guide (September 1996).pdf. Table 2, dates introduced and discontinued: Performa Display, September 1992 to July 1994; Performa Plus Display, September 1992, no discontinuation date (the guide says a missing date means the product is still available), p. 13 (PDF p. 31). Apple Performa Display/Plus chapter: parts list p. 192 (PDF p. 210), "The Apple Performa and Performa Plus Displays are whole-unit exchange modules", Performa Display .39 dot pitch, US 661-0114, Australia X661-0114, Europe Z661-0114, Pacific PA661-0114; Performa Plus Display .29 dot pitch, US 661-0113; Plus Display, 14" colour monitor, .29 dot 661-1669; locator view, Figure 52, p. 193 (PDF p. 211); symptom/cure chart pp. 194-195 (PDF pp. 212-213).
- ↑ 2.0 2.1 2.2 2.3 2.4 2.5 2.6 Apple Computer, Apple Performa Display/Plus (Service Source), 1995, hosted as File:Performa display.plus.pdf (see Apple Performa Display/ Plus Service Source). PDF page numbers: Characteristics p. 3; Controls p. 4; Physical and Electrical p. 5; Troubleshooting: General p. 7, Geometry p. 8, Synchronization p. 9, Video p. 10, Miscellaneous p. 11.
- ↑ 3.0 3.1 EveryMac, "Apple Performa Display Specs" (retrieved 2026-10-02). Released with the Macintosh Performa 400; introduced 14 September 1992; discontinued 18 July 1994; 0.39 mm dot pitch; original price US$305; 14.0 in (13.0 in viewable). Community specification list.